설명

Single point load cell H20A

The H20A is a high strength single point load cell with Dual beam system with a high natural frequency made from Aluminium. The load cell is suitable for low cost platform scales and weighing machines with accuracy class III.  
The load cell H20A is approved to OIML R60 up to 3000 and gives extremely accurate reproducible results, over a long term even in harsh industrial environments. This ensures that there will be no measurement error when the load is placed off centre, eg in a corner of a platform. The load cell is potted and meets the requirements of protection class IP65.

Typical Application

harsh environment small platforms, Counting scales, check weighing, Postal scales, Wending machines,Industrial filling and dosing processes, medical scales and pharmaceutical process.

Construction

These load cells operate on the principle of the double cantilever beam and thus ensure accurate measurements. The design is insensitive to off-center force application and can be used for pushed and pulled forces. Threaded holes for attaching the sensor or the defined force introduction ease installation.

Features

• Material: Aluminium 
• Capacity: 2 – 100 kg 
• Accuracy class C3, Y=10.000 
• Approved to OIML R60 up to 3000d
• Design: The measuring element is potted, Protection class: IP 65 
• Off center load compensated
• Load Cell is suitable for platform sizes up to 300 x 400 mm 
• Robust flat design for harsh industrial environment 
• Compatible with other sources

Mounting

The construction of a platform scale with this load cell is very simple. Two steel or aluminium plates of up to 300 x 400 mm are screwed on via the two screw-on surfaces at the top front or rear and at the bottom of the cable outlet.

Drawing

Versions