The series of torque measuring flange’s that we provide are based on the standard  ‘strain gauge’ principle. The TMFS units have an integral signal conditioner, which produce either analogue or digital outputs. These outputs are then transmitted through a non-contacting system.

There are no bearings between the rotor and stator and as such the unit is free from wear. The transducer has a very short flange to flange dimension and the rotor, being installed from one side, (normally the test specimen side) allows easy, cost effective assembly into a drive line. TMFS torque measuring flange’s are very robust and largely insensitive to bending and transverse forces.

Available in ranges from 50N up to 5000Nm
Mechanical connection: Flange
Accuracy Class 0.1
Linearity Error :<±0.05%
Output Signal: ±10Vdc
Overload Capacity 200%
Supply Voltage 11 – 30 V
Output signal at zero torque: 10kHz
Nominal output at +FS torque: 15kHz
Power Consumption: <5W