설명
C15 Reference Force Transducer: Capacities from 2.5 kN to 1 MN
The C15 reference force transducer is a rugged shear-force sensor – EMC-tested, rustproof, impact and vibration tested – available in nominal (rated) measuring ranges from 2.5 kN to 1 MN. It fulfills the requirements of ISO 376 accuracy class 00 across an exceptionally wide measuring range, from 10% to 100% of the respective capacity.
Thanks to the sensor’s very high output signal – more than 4 mV/V for variants with capacities of 25 kN and above – the C15 enables optimal use of the amplifier’s full measuring range. The result is high resolution and an outstanding signal-to-noise ratio.
- Accuracy class to ISO376: 00
- HBM accuracy class: 0.02…0.05
- Nominal (rated) measuring range: 2.5 kN…1 MN
The sister model of the C15, the U15 reference force transducer, is ideal for reference force measurements with tensile and compressive forces.
| Maximum capacity (nominal load) | 2.5 kN, 5 kN, 10 kN, 25 kN, 50 kN, 100 kN, 250 kN, 500 kN, 1 MN |
| Tensile / compression | Compression |
| Type/technology | Strain Gauge |
| Calibration | Fulfills ISO 376 |
| Output signal | mV/V (passive strain gauge) |
| Degree of protection | IP67 |
| Mechanical interfaces | Spherical load introduction |
| Height (without accessories) | 64.3 mm, 92 mm, 116 mm, 160.9 mm |
| Diameter (without cable or plug) | 104.8 mm, 153.9 mm, 203.2 mm, 279 mm |
Highest accuracy class
- Meets the requirements of class 00 per ISO 376 in an exceptionally wide measuring range between 10% and 100% of its capacity for compressive forces
- Eccentricity adjustment: Optimized accuracy even for measurements in different mounting positions or with eccentric force application
- Can be used as a reference transducer for compressive forces up to 1 MN
- Very high output signal of up to 4.5 mV/V; can be adjusted, on request, to 3 mV/V to make full use of the amplifier’s input range
- Excellent signal-to-noise ratio
Precise measurements in an exceptionally wide measuring range
Individually configurable
- Numerous easy-to-order options, TEDS chip, double bridges, rated output adjustment
- Practical accessories available, thrust pieces per ISO376
- On request, we can perform measurement-chain calibrations
- HBK has suitable measuring amplifiers available that are ideally matched to the C15 in terms of the input range
Match the measurement system perfectly to the application – with well-engineered accessories, the right amplifiers, and calibration services
Robust and fast
- High rigidity, low deformation under load, and good dynamic behavior
- Robust due to the IP67 degree of protection and hermetic welding
- Low temperature coefficient of the zero signal and low sensitivity to temperature gradients
Reliably masters dynamic calibration tasks in and outside of the laboratory
C15-Data-Sheet-B05086
상품평
아직 상품평이 없습니다.